| Repairing Window Shades and Rollers Information |
Window shades, cracked and torn at the bottom but otherwise in good condition, can be reversed to give good service. To repair a shade:
1. Take it from the window, unroll it full length on a flat surface and pull out the stick from the bottom hem.
2. Remove the shade from the roller, carefully lifting out the small tacks with a knife so they may be used again if possible. Staples may be used on newer shades.
3. Cut off the hem. This end will be retacked to the roller so must be straight. Cut exactly at right angles to the sides of shade.
4. Make a new hem. Trim and straighten the end that was removed from the roller; then fold and stitch a hem the same width as the hem you cut off. This new hem will be at the bottom of the finished shade.
5. Put the cut edge of the shade back on the roller absolutely straight so the shade will hang straight at the window. On most rollers there is a pencil line drawn from end to end by the manufacturer. If there is no line, draw one exactly down the middle of the roller and at right angles to the ends of it.
6. Use the old tacks, or about a no.2 1 size. Tacks must not go through the roller into the spring. Or staple.
7. Lay the roller on top of shade with the spring end toward the right.
8. Tack the unhemmed end of the shade back on the roller, placing it exactly on the pencil line. Hammer a tack into the exact center of the shade and the roller, and then at each end. Avoid old tack holes. Continue tacking about 3 or 4 inches apart. Keep the tacks in a straight line at an even distance from the edge of the shade all the way across.
This article was written by Anne Field, Extension Specialist, Emeritus.
MSU 2003
|
|
