Step
1. Remove the aluminum or plastic retainer strip from around the frame that holds the screen fabric. Be careful not to tear the plastic or break the aluminum strip. An ice pick or other sharp pointed object works well to remove either type of retainer.
(Vis. 1) Step
2. Using the torn screening as a pattern, cut the new screening. Plastic screening is usually used with aluminum frames. Cut the screen at least 1/2" wider than the pattern to be sure there is enough to hold when you put the retainer strip back. Cutting the screen even with the outside of the frame is a good size.
(Vis. 2) Step
3. Spread the screening over the frame and press the retainer strip into the groove. Temporarily fastening the screen with masking tape keeps it in place on the frame.
(Vis. 3) You may need a hammer to force the retainer strip into the groove. Do not strike the metal strip directly with the hammer but use a wood block about 3" or 4" long between the hammer and the strip. If a plastic strip is used it can be forced into the groove by hand pressure on a wooden block 3 to 4 inches long.
Step
4. Trim off excess screening with a kitchen scissors or a knife or razor blade.
(Vis. 4) This article was written by Anne Field, Extension Specialist, Emeritus, with references from Michigan Extension bulletin Repairing and Replacing Screens.
Replacing Screen on Aluminum Frames Pictures MSU 2003
